KUZMA 4POINT TONEARM In
7. Adjustment of azimuthTo make azimuth adjustments, release the two screws locking the mechanism at the centre top of the main tonearm tube, with All
9. DampingThis tone arm has two independent damping systems. The lower trough is for horizontal damping and the second trough on the arm tube asse
Fig.11 Removing vertical trough Fig.12 Removing horizontal trough Fig.13 Both troughs removed10. Cueing device adj
11. MaintenanceThe bearing does not need maintenance. Clean dust from the tonearm with a dry cloth and use a soft cloth and alcohol to remove silicon
APPENDIX 1Tangential Cartridge geometry adjustmentOnce the cartridge has been mounted, it is necessary to ensure that the cartridge is tangential to t
Fig. 14 Alignment at ATo rotate or readjust cartridge:4. Slightly loosen the screws which attach the cartridge to the headshell. 5. Holding headshe
Fig.16 Stylus tip is in front of zero point B.10. Now rotate protractor and again position stylus at zero point A as described in 5 and 6 above, ens
REMEMBER STEPS:a) Put stylus at zero point A and by rotation align cantilever along XY line.b) Align cantilever along XY line at zero point B by rot
Significantly improved sound can be obtained by paying attention to azimuth adjustment prior to final VTA adjustment. Appendix 3Fine bias adjustment1.
Cartridge Protractor ( Not in correct scale) Tonearm mounting protractor19A X Y SB X
KUZMA LTD INSTRUCTION MANUAL FOR 4POINT tonearmThe 4POINT tonearm is a very precisely engineered piece
General description :This differs from other arms by incorporating several unique features. The zero play bearing is configured on 4 points. There
Fig. 2Technical data: Mass: 1650 grEffective length : 280 mm ( 11 inch)Mounting distan
1. UnpackingOpen the box carefully and remove top covers.The tube with vertical bearing points is packed separately (tube assembly) on the top of the
Fig.3 Protractor for pivot to spindle distance Remove the fixing foam on the horizontal bearing assembly. Check that the bias thread is fi
Fig.4 Assembling the tube onto the horizontal bearing tower. Cartridge mounting:Mount the cartridge with the appropriate set of 2.5 mm screws. When
Fig.7 Removing headshell Fig. 7A Headshell’s fingerliftBalancing of the tonearm:Fix car
4. Adjustment of tracking forceBalance the tonearm with the tracking scale, which must be at record height. Rotate the smaller counterweight towards
Kommentare zu diesen Handbüchern