1 Instruction manual KUZMA AIR LINE AIR BE
105.0. Tonearm Setup: Note: See also 4.4.3. On the tonearm remove the protective shaft cover and the security wire which has restricted movement o
11In the unlocked position rotation of the counterweight is easy. To begin with, the tonearm should be balanced to zero tracking force. This is not
12 Protractor – position from top Move the cartridge along the headshell to such a distance, that the tip of the diamond (needle) is on the line on
13Now you can start playing LPs. On a spinning record gently lower the needle into the first groove. When the needle touches the record it will mov
14 To make VTA adjustment easier, you can rotate the ring while holding the main knob to adjust the zero starting point on the knob.
157.0. Damping: A damping system, consisting of a paddle, damping trough and silicone oil, can also be retrofitted on all Air Line ton
168.0. Zero Switching kit (optional): The function of the “zero switching kit” is to eliminate the noise of the compressor switching ON and OFF being
17Air bearing assembly and bearing shaft with cueing device-blocking plate removed. Protect the cartridge. Do not slide the bearing without compress
1810.0. Troubleshooting: NOTE: Check our web site for frequently asked questions (FAQ) for some more answers. See also appendix of this
1910.5. Compressor does not start: Check the mains electricity. Compressor was overheated and overheating protection switches it off. Overheating pr
2KUZMA LTD INSTRUCTION MANUAL FOR AIR LINE tonearm The Air line tonearm is a very precisely engineered piece of equipment. However the
31.0. General description: Main outer box contains two inner boxes. One box contains the compressor with oil, PVC double drain bottles and the second
42.0. Unpacking: Compressor with “double drain bottle system.” 2.1. Compressor box: Open the box and lift up the compressor by the handle. It i
53.0. Setup description: Do not slide the tonearm bearing unnecessarily without compressed air! Do not tilt the compressor while it contains oil! For
6If necessary the PVC tube can be cut to length with a sharp knife. Position the tube on a hard surface and cut down at 90 degrees. 4.0. Air supp
7 At the front of the compressor is a pressure regulator with filters and pressure gauges and at the other end of compressor is the main cable and i
8Note: Every week or so this should be open for a few hours when the compressor is running! 4.2. Air tubes: Connect the PVC tubes in blue &a
94.4. Air pressure Setup: Note: keep valves on air tube supply and tonearm in the closed position. All tubes must be connected. 4.4.1. Compressor O
Kommentare zu diesen Handbüchern