1 KUZMA AIR LINE AIR BEARING TONEARM
10 4. Adjustment of tangential geometry Protractor Put a record on the platter and, using the cueing device lever, lower the cartridge on to t
11 Move the cartridge along the headshell to such a distance, that the tip of the diamond (needle) is on the line on the protractor, which
12 The tone arm is correctly levelled when: Above the outer grooves whole assembly should move slowly away from the record.
13 Of course the use of a test record and osciloscope is mandatory for optimal azimuth. VTA changes and even changes in the height
14 Damping system Damping change Release black plastic
15 Mainentance When air is consumed, the compressor works automatically, aproximately every minute and then rests for about a
16 Spread cloth over the platter under the blue bearing and from bottle, squeeze alcohol on to the inside of the bearing, which will then drain
17 Problems Cartridge skips the groove: Tonearm is not horizontal: check horizontality Excessive dirt on record: check and clean for small p
2 KUZMA LTD INSTRUCTION MANUAL FOR AIR LINE tonearm The Air line tonearm is a very precisely engineered p
3 General description: Main outer box contains two inner boxes. One box contains the compressor with oil and PVC drain bottle and the se
4 1. Unpacking: Compressor with drain bottle Compressor box: Open the box and lift up the compressor by the handle. It is a heavy item. Rem
5 Basic setup: Mount the armbase onto armboard. The dimension and position is the same as for Stogi ton
6 Compressor: for details see instructions with the compressor. The compressor has a safety valve and overheating protection!
7 filters. On one end of this longer part is a valve. This end should be connected to the red filters. The valve lever should be in »close position«
8 *Valve on drain tube: Optional by order. For normal operation this should be open (level along axis of tube). If used in the same room as tone a
1. Setting up the tonearm: Again check the height of the tonearm. The basic height should be such, that the centre of the shaft (centre of vertic
Kommentare zu diesen Handbüchern